Toothbrush Handle - Philips Sonicare 700 series Instructions Manual

Healthywhite
Hide thumbs Also See for Sonicare 700 series:
Table of Contents

Advertisement

Available languages

Available languages

ENGLISH
10
4235.020.2528.2.indd 10
4235.020.2528.2.indd 10
2
Wrap excess power cord around the gray charger base as shown in
the picture. Be sure to wrap the cord on the inside of the two snap
levers.
3
When you have stored the excess cord, guide the power cord
through the small groove in the rear of the gray charger base.
4
Reattach the charger cover by pressing it down over the charger
base until it snaps into place.
Tip: For extra convenience during travel, you can remove the travel charger and
use it without the charger cover and charger base.
Cleaning
Do not clean brush heads, handle, charger or charger covers in the
dishwasher.

Toothbrush handle

1
Remove the brush head and rinse the metal shaft area with warm
water.
Do not push on the rubber seal on the metal shaft with sharp objects, as
this may cause damage.
2
Use a damp cloth to wipe the entire surface of the handle.
Brush head
1
Rinse the brush head and bristles after each use.
2
Remove the brush head from the handle and rinse the brush head
connection at least once a week with warm water.
Charger
1
Unplug the charger before cleaning.
2
Use a damp cloth to wipe the surface of the charger.
10-07-2008 10:56:36
10-07-2008 10:56:36

Advertisement

Table of Contents
loading

Table of Contents