Table of Contents
Advertisement
2.3.4
Installing a DIMM
Make sure to unplug the power supply before adding or removing DIMMs or
other system components. Failure to do so may cause severe damage to both
the motherboard and the components.
To install a DIMM:
1.
Unlock a DIMM socket by pressing
the retaining clips outward.
2.
Align a DIMM on the socket
such that the notch on the DIMM
matches the break on the socket.
3.
Firmly insert the DIMM into the
socket until the retaining clips
snap back in place and the DIMM
is properly seated.
•
•
2.3.5
Removing a DIMM
To remove a DIMM:
1.
Simultaneously press the retaining
clips outward to unlock the DIMM.
Support the DIMM lightly with
your fingers when pressing the
retaining clips. The DIMM might
get damaged when it flips out with
extra force.
2.
Remove the DIMM from the socket.
2-12
A DDR2 DIMM is keyed with a notch so that it fits in only one direction. Do
not force a DIMM into a socket to avoid damaging the DIMM.
The DDR2 DIMM sockets do not support DDR DIMMs. Do not install DDR
DIMMs to the DDR2 DIMM sockets.
3
1
Unlocked retaining clip
1
DDR2 DIMM notch
Chapter 2: Hardware setup
2
DDR2 DIMM notch
1
2
1
Advertisement
Table of Contents
