Miele H 5981 BP Operating And Installation Instructions page 76

Problem solving guide
Problem
"Maximum operating
duration reached"
appears in the
display.
The oven has
automatically
switched itself off
after a cooking
programme.
A fault code
appears in the
display: F + a
number
76
Possible cause and remedy
Safety switch-off has been activated.
The appliance will be ready for use again after it has been
switched off and then back on again.
The oven switches off automatically to save energy if, at the
end of an Automatic programme or a cooking programme
with Automatic switch-off, no other cooking function is
selected within a certain time period.
The oven is ready for use again when you switch it on.
You can rectify the faults with the following codes yourself:
– Fault 23: The temperature required for pyrolytic cleaning
was not reached.
This could have been caused by too much soiling in the
oven to start with.
Remove all coarse soiling before starting the pyrolytic
cleaning programme again.
If the fault message appears again please contact the
Miele Service Department.
– Fault 32: The door has not locked for the pyrolytic
cleaning process.
Switch the oven off and start the pyrolytic cleaning
process again.
If the fault code appears again call the Miele Service
Department.
– Fault 33: The door lock for the pyrolytic cleaning process
will not open.
Interrupt the pyrolytic cleaning programme by switching
the oven off. If the door will still not open please contact
the Miele Service Department.
For all other fault codes please contact the Miele Service
Department.