INSTALLATION INSTRUCTIONS FOR ABF GLASS DOOR/END PANEL PACKAGED SET
Lennox's Glass Door/End Panel Packaged Set, Models 38ACR and
38ACR-BB, are designed to be installed on the CR-3835R/L Series
fireplaces. These kits come complete with all of the required hardware
necessary to complete the task.
Please read and understand these instructions carefully before begin-
ning installation and operation. Do not attempt to alter or modify the
construction of these glass door assemblies as it could cause a malfunc-
tion or possible fire hazard.
The Models 38ACR and 38ACR-BB have been tested and listed by Omni
Test Laboratories, Inc.
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE.
GENERAL INFORMATION
Before starting the installation of the glass doors and end panel, assure
the kit is complete and undamaged. Refer to Figure 1 and the inventory
list to identify all necessary parts.
INVENTORY LIST
A. (1) Top Channel (door)
B. (1) Bottom Channel (door)
C. (1) Top Channel (panel)
D. (1) Bottom Channel (panel)
E.(1) Corner Post
MODELS 38ACR AND 38ACR-BB
F. (1) Glass End Panel
G. Door Panel Assembly LH
H. Door Panel Assembly RH
J. (2) Baffles
K. Hardware Kit (Including
Handles) Installation Instructions
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE
904665
REV. C 03/2008
A
G
B
Figure 1
END PANEL INSTALLATION STEPS
Step 1. Remove the screen rod covers from the front and corner
openings. Remove two angle retainers and replace screws.
Note: Units are shipped without covers installed.
Step 2. Refer to Figure 2 and remove the top two outer screws and loosen
the bottom screws at least two (2) turns. Remove corner shipping post,
if installed.
CAUTION: REMOVE THE PLASTIC PROTECTIVE COATING FROM ALL
BRASS PIECES BEFORE INSTALLATION.
FIREPLACE KITS
AND ACCESSORIES
GLASS DOOR/END PANEL
J
H
F
D
US
K
C
E
1