Miele F1471VI Operating And Installation Manual page 22

Ice/Water Dispenser
Turning on the Ice/Water
Dispenser
Before using the Ice/Water
Dispenser for the first time, you must
flush the water lines.
^ Open the freezer door.
^ Be sure the ice cube container is
under the ice maker.
Ice cubes can only be produced if
the ice cube container is completely
closed.
^ Touch the "ice" button so it turns
yellow.
^ Close the freezer door.
The ice/water dispenser is now ready
for use.
After opening and closing the door,
it may take a few seconds before the
Ice/Water Dispenser is ready for use
and the touch controls can be used
again.
22
^ Turn on the Ice/Water dispenser with
a finger touch to the control panel or
by passing your hand under the
dispenser to activate it via the light
sensor.
All of the touch controls for the
Ice/Water Dispenser should now
appear white.
If this is not the case, the Safety Lock is
activated i.e. "lock" will appear yellow.
See "Safety Lock".
If "lock" is blinking, the drip tray
needs to be emptied (see "Cleaning
and care").
Once the freezer has cooled to a
freezing temperature, the ice cube
maker fills with water.
Do not place any bottles or food for
rapid cooling in the ice cube maker.
The ice cube maker could become
blocked or damaged.
Discard all ice cubes, crushed ice
and water produced during the first
24 hours after switching on the
ice/water dispenser. The water is
used for the initial flushing of the
water supply.
This applies to the first use, as well
as when the appliance has been out
of service for a long time.