Download Print this page

Aligning The Front Of The Plate Warmer - Miele EGW602-14 Operating And Installation Instructions

Miele built-in plate warmer operating and installation instructions
Hide thumbs

Advertisement

^ Remove the protective foil from the
adhesive strips.
^ Align the metal strips flush against
the side and rear walls of the cabinet
a and stick them on to the plate
warmer b (see illustration).
The third metal strip is not needed if the
cabinetry does not have a rear panel.
^ Install the combination appliance in
accordance with its own specific op-
erating/installation instructions and
then connect the electrical supplies.
After installing the combination appli-
ance, it may be necessary under cer-
tain circumstances to
– align the front of the plate warmer.
– align the gap between the plate
warmer and the combination appli-
ance.
To help you do this, there are adjusting
points underneath the nuts which se-
cure the drawer to the telescopic run-
ners.
^ Loosen the nuts and take the plate
warmer drawer out.
Use the adjusters to align the drawer
correctly.
17

Advertisement

loading

  Also See for Miele EGW602-14

  Related Manuals for Miele EGW602-14

This manual is also suitable for:

Egw 601-14Egw 602 - 14