Rear Wheel Installation - Honda NT650 Owner's Manual

7. Remove the wheel from the drive pins
F
(10), then angle it to the right and pull it
R
backward to go between the brake disc
(11) and muffler.
A
8. Then as the wheel reaches the hub,
M
angle it to the left and pull it out
backward as shown.
E
/
Installation Notes:
 Install the axle aligning the spline with
W
the wheel hub.
 Coat the axle threads with grease.
H
 Clean the wheel hub and wheel mating
E
surface.
 Align the index marks (1) of wheel hub
E
with the wheel and install the wheel hub
L
over the drive pins.
 Tighten and torque the wheel nut to the
S
specification.
/
120 Nm (12 kgm, 87 Ibft)
 Install a new cotter pin and the cap
B
securely.
R
 Turn
the
A
counterclockwise until it stops.
 Install the chain on the rear sprocket.
K
Adjust the drive train (page 65).
E
S
72
bearing holder
 Apply the rear brake several times and
check for free wheel rotation when
released.
⚠
WARNING
* If a torque wrench was not used f o r
i n s t a l l a t i o n ,
authorized Honda dealer as soon as
possible to v e r i f y proper assembly.
Improper assembly may lead to loss of
braking capacity.
(1) Index marks
s e e y o u r