Electrical Connection - Miele KM 88-2 Operating Instructions Manual

Electrical connection

Electrical connection of the appliance
should be made by a qualified electri-
cian in accordance with local and na-
tional ordinances.
Note to the installer:
Please leave these instructions with
the consumer.
Power supply:
Please check the dataplate for
240 VAC; 60 Hz or
208 VAC; 60 Hz
Caution:
Disconnect the appliance from the
main power supply before servic-
ing. To reduce the risk of electric
shock, make sure that the ap-
pliance is properly grounded after
installation.
WARNING:
THIS APPLIANCE MUST BE
GROUNDED
Electrical connection
For CDN only
The appliance is provided with 3 termi-
nal leads: 1 black wire, 1 red wire and
1 green wire which have to be con-
nected to a separate overcurrent pro-
tection device (fusebox).
All hot wires (black and red) have to be
fused individually before connecting
them to the main power supply leads.
Use 15 Amp fuses for appliances
rated 240 VAC.
Connect black terminal wire to L1
(black) and red terminal wire to L 2
(red). The green terminal wire (ground)
has to be connected directly to the
equivalent colored power supply leads.
All connections must be done in a
proper way.
ALSO SEE THE WIRING DIAGRAM
PROVIDED WITH THE APPLIANCE.
For USA only
The appliance is provided with 3 termi-
nal leads: 1 black wire (L 1), 1 red wire
(L 2) and 1 green wire (GND) which
should be connected to a dedicated
line inside of an approved junction box.
Connect the black wire to L 1, the red
wire to L 2, and the green wire to GND.
ALSO SEE THE WIRING DIAGRAM
PROVIDED WITH THE APPLIANCE
13