Miele CVA 4070 Operating And Installation Instructions page 45

^ The display will prompt you through
the next steps:
– to fill the descaling agent into the
water tank
– take the water tank out
– fill the water tank with fresh lukewarm
tap water to the mark k. If not filled
to the mark, the descaling will be
canceled prematurely and
incomplete
Dissolve two of the enclosed
descaling tablets in the water. Close
the water tank and insert into
position.
^ Set the descaling funnels under the
hot water and froth dispensers. Set
the funnel in the holes of the drip tray
so the dispensed liquids are guided
in the drip tray.
During the descaling process the
descaling solution will flow from the hot
water and froth dispensers. The
machine rests briefly to allow the
solution to take affect before
dispensing again.
Descaling the appliance
^ Please fill the water tank with tap
water to the descaling mark and
reinsert it: Take the water tank out,
rinse out any descaling residues
thoroughly with water. Fill with fresh
water to the k mark.
During rinsing water runs from the
dispensers. When the display shows
Please empty the drip tray: Empty the
drip tray. Since the machine is also
rinsed inside, the drip tray needs to be
emptied to continue rinsing.
When the display shows: Process
finished: Descaling is complete. Follow
the prompts in the display. The
appliance is rinsed a final time.
Since the lines are drained during
descaling, they must be filled with
water before the next use. See
"Making coffee - Cappuccino and
milk froth".
45