Aligning The Appliance - Miele KWT 1601 Vi Operating And Installation Manual

^ Plug the appliance into the power
outlet .
The plug of the appliance should be
easily accessible after installation.
If the plug is not accessible after the
appliance has been installed,
disconnection from the power
supply should be completed via the
circuit breaker.
In the case of side-by-side
installations, a separate outlet must
be used for each appliance.
^ To prevent the power cord from
becoming caught:
Tie a piece of string to the middle of
the power cord and feed it forward
under the appliance. When sliding
the appliance in, pull the cable
forward .
^ Carefully slide the appliance into the
space until the height-adjustable
wheels interlock with the anti-tip
brackets .
If resistance is felt when attempting to
slide the appliance into the installation
niche - for example, because the floor
is uneven,
^ Turn the rear adjustable wheels
slightly outward (see "Aligning the
appliance"), then push the appliance
in.
Be careful not to damage the power
cord attached to the floor.
^ Remove the edge protector

Aligning the appliance

^ Align the appliance with the custom
front.
The installation aids
appliance door have been designed for
custom door thicknesses of 3/4" (19
mm) and 1 1/2" (38 mm).
The height-adjustable feet at the front
and rear can all be adjusted from the
front:
– Front feet:
Adjust with a rachet (5/16" / 8 mm)
– Rear feet:
Adjust with a (cordless) screwdriver
and/or a rachet (5/16" / 8 mm) for fine
adjustment
^ Use a level to align the installation
aids
.
Installation
on the
on the door.
51