Adjusting The Door Opening Angle (Optional Accessory) - Miele KWT 1601 Vi Operating And Installation Manual

Installation
Installation with partition using the
"Merging Kit"
The minimum thickness of the partition
5
is / " (16 mm).
8
If there is a partition with a thickness
5
from / " (16 mm) to 6
8
between the adjacent appliances, then
each appliance should be individually
installed within its own niche using the
mounting accessories included.
The "Merging Kit" will also be needed.
The "Merging Kit" is available from
Miele.
Installation with partition without
using the "Merging Kit"
If there is a partition with a thickness of
5
more than 6 / " (160 mm) between
16
the adjacent appliances, then each
appliance should be individually
installed within its own niche using the
mounting accessories included (the
"Merging Kit" is not necessary).
38
5
/ " (160 mm)
16
Side panels
If one side of the appliance is visible, a
side panel must be used.
The side panel must be firmly secured
to the wall, the floor and the overhead
furniture/fixtures before the appliance is
placed in the cavity.
The dimensions of the side panel are
taken from the opposite wall of the
installation space. During installation,
ensure that the cavity is square and the
measurements are correct.
Adjusting the door opening
angle (optional accessory)
Depending on the installation site, it
may be necessary to adjust the door
opening angle to 90°.
^ Open the door.
^ Insert the banking pin through the
holes and drive in with a hammer.
The door opening angle is now limited
to 90°.