Rack Cleaning - Bosch HSLP451UC Use And Care Manua

Built-in steam convection oven
Hide thumbs Also See for HSLP451UC:
Table of Contents

Advertisement

Available languages

Available languages

DO NOT press ENTER before following the instructions
below:
Descale Phase (cycle 2, approximately 20 seconds)
7. Remove the water tank and wash it out thoroughly. Fill
it with water and slide it back in.
— If the water tank is not refilled and the ENTER
button is pressed, the action will be ignored. The
rinse cycle can only be completed if the water tank
is refilled.
8. Wipe any remaining water from the evaporator dish
with a cleaning sponge. Wipe out the oven. Thoroughly
rinse out the cleaning sponge.
9. Press ENTER to start the first rinse cycle.
— The display will show 1ST RINSE. The countdown
will resume, and after a short time (about 20
seconds), a beep will signal the end of the first
rinse.
— The display will show CLEAN DISH and PRESS
ENTER BUTTON.
10. After 20 seconds, a beep will signal the end of the first
rinsing cycle.
— The display will show CLEAN DISH on the first line
and PRESS ENTER BUTTON on the second line.
11. Wipe any remaining water from the evaporator dish
with a cleaning sponge.
Rinse Phase (cycle 3, approximately 20 seconds)
12. Press ENTER to start the second rinse cycle.
— The display will show 2ND RINSE. The countdown
will resume again.
— After 20 seconds, a beep will signal the end of
DESCALE. The display will show DESCALE
FINISHED and CLEAN DISH.
13. Wipe any remaining water from the evaporator dish
with a cleaning sponge. Wipe out the oven. Thoroughly
rinse out the cleaning sponge.
14. Dry the oven cavity with a soft cloth.

Rack Cleaning

Removing racks
1. Carefully press the front of the rack up until it unhinges
and release it sideways from the bracket (image A).
2. Unhinge the rack from the bracket and remove it
(image B).
3. Clean racks with dish detergent and dish sponge/brush
or clean racks in the dishwasher.
Reinserting racks
1. Insert the rack with the indentations facing up. The
racks each only fit on one side.
2. Hook rack in back and push it back until it engages
(image C).
3. Hook rack on the front bracket and press down until it
engages and is horizontally secured in the appliance
(image D).
English 29

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents