Power Supply; Fitting The Column - Seca 769 Owner's Manual

Power supply

The scale is generally powered by batteries.
The LC display has a low power consumption – 10,000 weighing operations can be per-
formed with one set of batteries.
– Carefully turn over the scale so that the
base of the scale is accessible.
– Push the battery compartment closure
towards "Battery" and open the cover.
– Connect the cable to the holder and
batteries.
– Place the holder in the battery compart-
ment.
– Close the cover and then turn the scale
back up the right way.
Note: the scale is prepared for use with a seca mains unit which is available as
an accessory.
The connection socket for the mains unit is
in the base of the scale.
Note: the mains unit can also be used
with the batteries in place without the
scale or batteries being damaged.

Fitting the column

The column and display head are fitted to the weighing platform.
– Guide the connecting cable through the
opening.
– Place the column in the recess. The
display should be legible for people
standing on the scale.
– Screw the column to the weighing plat-
form from underneath.
– If necessary, lay the scale carefully on
its side to tighten up the screws.
– Connect the plug of the connecting
cable to the rear of the scale.
– Then place the scale upright again.
Model 769
scale from
mains unit
underneath
plug-in
GB 13