Connecting to a Wi-Fi network
u
From the Home screen,
1
u
[Settings]
[Wi-Fi].
Select a Wi-Fi network to connect.
2
To connect to a protected Wi-Fi
・
network, enter the
u
password
[Connect].
To connect Wi-Fi network with WPS
・
u
compatible device,
or
[WPS Pin
Entry]. Follow the onscreen instructions.
Scanning for Wi-Fi networks manually,
・
u
[Scan].
❖ Information
When Wi-Fi network is disconnected by turning Wi-Fi
・
off, a Wi-Fi network will automatically be connected if
available Wi-Fi networks are found when Wi-Fi is
turned on.
When the terminal is connected to Wi-Fi network
・
successfully, "Connected" appears. When a different
message appears, make sure the password (security
key).
When "Connected" does not appear even if you enter
a correct password (security key), the correct IP
address may not have been acquired. Check the
signal status and reconnect.
* It may take 5 minutes or more to display the
message after [Connect] is tapped.
To use docomo service via Wi-Fi, setting "docomo ID"
・
u
u
is required. From the Home screen,
[Settings]
u
[docomo service/cloud]
[docomo ID
(docomo
設定
ID setting)] to set.
Settings
Page 143