Table of Contents
Advertisement
A.1.2 Removing the top cover
To remove the top cover:
1.
On the Subsystem rear panel, locate the two screws that secure the
top cover to the chassis.
2.
Use a Phillips (cross) screw driver to remove the top cover screws.
Keep the screws for later use.
3.
Pull the top cover slightly toward the rear panel until the side tabs are
disengaged from the chassis.
4.
Hold the center edge of the top cover, then lift it up from the chassis.
Set the top cover aside.
A.1.3 Installing a hard disk drive
Set your hard disk drive as Slave device before connecting the IDE cable
and power plug. Refer to the HDD documentation on how to set the drive
as a slave device.
To install a hard disk drive
1.
Connect the 40-pin IDE cable
to the IDE connector on the
drive.
2.
Connect the 4-pin power plug
to the HDD power connector.
3.
Place the drive on the tray.
4.
Secure the drive with two side
screws.
5.
Replace the top cover.
Appendix
:
1
2
3
4
A-3
Advertisement
Table of Contents
