Instructions For Use; A Fitting & Removing The Parts - Cuisinart CH4BCU User Manual

Instructions For Use

A Fitting & removing the parts
1. Place the housing base on a flat, dry, stable surface.
2. Place the work bowl over the motor base with the handle facing forward.
N .B . Opening at the back of the bowl must face column at the back of Mini
Processor .
3. Turn the bowl in an anticlockwise direction until it locks into position on the housing
base.
4. Carefully lift the blade assembly, holding the central plastic stem and place over the
motor spindle. Push the blade down until it clicks into place. The lower part of the
blade assembly should almost touch the bottom of the work bowl.
5. To remove blade, pull up and away using gentle force.
N .B . Always hold the blade assembly from the plastic stem . Never touch the blade
as it is very sharp .
N .B . Never place the blade on the motor shaft until the work bowl is locked into
place .
N .B . Always insert the blade in the work bowl before adding ingredients .
6. Add the food you wish to process.
7. Place the lid on the work bowl with the long tab to the right of the rear column.
While holding the housing base with your left hand, securely grip the handle on the
top of the lid and turn in an anticlockwise direction until the descending tab locks
into the locking post.
N .B . If the tab does not lock in the post, the motor will not start .
8. To remove the lid, hold the housing base with your left hand, securely grip the handle
on the top of the lid and rotate it in a clockwise direction.
N .B . Make sure the motor has completely stopped and the blade has stopped moving
before removing the lid .
9