Page 1
® INSTALLATION GUIDE Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit vikingrange.com Ventilation Hoods (101912)
Follow the heating equipment single speed ventilator. All Viking ventilator kits are manufacturer’s guideline and safety standards designed specifically for use with Viking hoods. Use of any such as those published by the National Fire non-Viking ventilator kit will void the hood warranty.
Dimensions & Specifications IMPORTANT– Please Read and Follow! (BVWH 18”H. Wall Hoods 36”, 48”, & 60”) W A R N I N G To reduce the risk of injury to persons in the event of a rangetop grease fire, observe the following.
Planning Information Exterior Ventilator Dimensions (BVWH 18”H. Wall Hoods) Proper installation of ducting is extremely important to ensure maximum performance 300 or 600 CFM Top View Roof cap single blower from any ventilation product. interior-power typical ductwork • All CFMs are based on tests at 0.1 static 7”...
Installation (BVWH 18”H. Wall Hoods) 6 ” 1-1/2”x 3/4” Slot for (3.8 cm) x (1.9 cm) wood strip 5/16” 5/16” wood strip nut driver nut driver Slide filter front over front lip. Push filter rear up, then Slide filter front over front lip. Push filter rear up, then Measure down 1-13/16 (4.6 cm) from desired height of Use additional mounting screws to secure hood to slide back over rear lip.
Service & Registration Wiring Diagram Service & Parts Only authorized replacement parts may be BRIGADE BUILT-IN HOODS used in performing service on the appliance. Do not repair or replace any part of the appliance unless specifically recommended in the manual. All other servicing should be referred to a qualified technician.