Energy Efficiency - AEG 47102V-MN User Manual

26 www.aeg.com
appliance into the circular hole on
the bracket. Screw it into the wall.
4. Check that the anti-tilt protection (A)
fits minimum 20 mm into the hole in
the rear wall of the appliance (B)
when you push the appliance.
13.5 Electrical installation
WARNING!
The manufacturer is not
responsible if you do not
follow the safety precautions
from Safety chapters.
This appliance is supplied without a main
plug or a main cable.
13.6 Covering terminal board

14. ENERGY EFFICIENCY

14.1 Product information for hob according to EU 66/2014
Model identification
Type of hob
Number of cooking zones
Heating technology
• The recommended cross-section area
• When you refit the mains terminal
50 mm
77 mm
A
• Make sure that the cover is securely
13.7 Terminal board
Make sure that the links are fitted as
shown.
47102V-MN
Hob inside Freestanding Cooker
4
Radiant Heater
is six square millimetres (6 mm²).
cover, make sure that the lower tabs
are located inside the bottom edge of
the aperture, before you fix the two
screws into the top edge of the mains
terminal cover.
fastened.
To open the cover of
terminal board obey the
procedure in opposite
sequence.
Do not remove blanking
plates.
L L N N N