Table of Contents
Advertisement
Installing Modem in Windows 3.x and NT 4.0
1. For NT , Check the Devices applet in the Control Panel to make sure
PCMCIA support is enabled. The startup type should be "boot" and the
status should say "started".
2. Power off your computer.
3. Insert the modem card into a PCMCIA card slot on your computer. Make
sure that the card is completely inserted and mated securely to the computer.
4. Connect one end of the RJ11 phone cable to the XJACK® connector on the
modem.
5. Connect the other end of the modem cable to an analog telephone line
6. Power on your computer, start Windows
The modem is now ready for use.
Installing Modem in Windows95
1. Power on your computer, start Windows95.
2. Insert the modem card into a PCMCIA card slot of your computer. Make
sure that the card is completely inserted and mated securely to the computer.
3. New Hardware Found will be on the screen.
4. Select option Driver from disk provided by hardware manufacturer
5. Click on OK.
6. Insert the Windows95 Installation diskette into diskette drive A:
7. Click on OK.
8. Follow the Windows95 prompts to complete installation.
9. Connect one end of the RJ11 phone cable to the XJACK® connector on the
modem.
10. Connect the other end of the modem cable to an analog telephone line
The modem is now ready for use.
PCMCIA 33.6 Data/FAX/Voice Modem
2-2
Advertisement
Table of Contents
