Inserting Batteries; Display - Mitsubishi Electric PAR-FL31MA Instruction Manual

4-2. Inserting Batteries

1 Remove the battery cover and insert the bat-
teries.
Press the area marked "
finger and slide the cover to remove.
™ All the LCD displays will light up for 3 seconds when the reset button is pressed.
™ Be sure to press the reset button whenever the batteries are replaced.
™ The controller may malfunction if the reset button is not pressed after the batteries have been
replaced.
Batteries
™ The batteries have run out when the "
cannot reach the receiver of the air-conditioner or when the LCD becomes weak. In these cases,
replace the batteries with new alkaline batteries (size AAA). (Make sure that both batteries are
replaced.)
™ Using manganese batteries will reduce the distance the signals can reach.
™ Do not use rechargeable batteries (Ni-Cd).
™ The life of alkaline batteries is approximately one year.
™ Remove the batteries if the remote controller will not be used for a long time.
Note:
Do not change the settings on the
adjusting switch and pair number
switch when the battery cover is re-
moved. Doing so will disable control.
8
2 Replace the battery cover and press the reset
button.
" with your
" mark (battery voltage drop) appears, when the signals
Nrm
Adjusting
switch
Wireless remote controller operating section
(When the battery cover is removed)
Re-place the battery cover.
Set
Pair number
switch