Dimensions 7 mm and 11 mm show the
space taken up by the frame of the
appliance on the worktop.
^ Make a cut-out in the worktop, paying
attention to the appliance height.
Dimension "B" applies to a number of
appliances and is shown on the chart.
^ A minimum safety distance of 50 mm
must be maintained between the
appliance and the back wall and a
side wall to the right or left.
^ Seal the cut surfaces with a suitable
sealant to avoid swelling caused by
The materials used must be heat
± 1 mm
The maximum tolerance for the worktop
cut-out must not exceed ± 1 mm.
When building in several combiset
appliances, a spacer bar must be
fitted between each unit.
(= Dim B)
± 1 mm