Operating The Base Station On The Pabx; Changing The Dialling Mode; Setting Recall; Setting Access Codes (External Line Prefixes) - Siemens Gigaset A580 IP User Manual

Operating the base station on the PABX

Operating the base station on the PABX
The following settings are only necessary when your PABX requires them; see
the PABX user guide. The settings only affect fixed line network connections.
You cannot send or receive SMS messages on PABXs that do not support Calling
Line Identification.

Changing the dialling mode

You can set the dialling mode.
¢
§§Menu§
Tone / Pulse
a
Please remember
u
Suffix dialling (for selecting the connection) is not possible in conjunction
with pulse dialling: a hash "#" is displayed during dialling but ignored when
pulse dialling is used.
u
Enter an asterisk "*" to switch temporarily to tone dialling. The asterisk is not
displayed.

Setting recall

Your phone is preset at the factory for operation on the main connection (recall
250 ms). For operation on a PABX, you may have to change this value. Please
refer to the user guide for your PABX.
¢
§Menu§
q
The current setting is indicated by ‰.
a

Setting access codes (external line prefixes)

Depending on your PABX, you must dial an access code before making external
calls in order to obtain an external line. You can store this access code in your
phone. It is then added automatically to the numbers, e.g. when dialling using
the calls list.
¢
§Menu§
Access Code
~
a
If an access code is set, the following applies:
104
¢ ¢
Settings Base
Select and press
§OK§
Press and hold (idle status).
¢ ¢
Settings Base
Select recall and press
Press and hold (idle status).
¢ ¢
Settings Base
Select and press
§OK§
Enter or edit the access code (maximum three digits) and press
Press and hold (idle status).
¢
Telephony Fixed line
(‰ = on).
¢
Telephony Fixed line
.
§OK§
Additional Features
.
¢
Dialling Mode
¢
Recall
.
§OK§