Yamaha MDX-E100 Service Manual page 20

Hide thumbs Also See for MDX-E100:
Table of Contents

Advertisement

MDX-E100
Error on display
Can' t Edit
TMP Over!!
DISC ERR R
DISC ERR S
DISC ERR W
TOC ERR S
TOC ERR R
U TOC W ERR
FOCUS ERR
BLANK DISC
TOC W ERROR
EEPROM ERROR
Mechanism Error
Error on display
MECHA_ERR2_*
MECHA_ERR3_*
* = E
Eject completed position
* = M Horizontal midway position
* = L
Load completed position
* = D
Head down position
19
Description
• Editing conditions were not satisfied with respect to
each editing function.
• The temperature in the set (MD unit) went up exces-
sively high due to occurrence of some abnormality.
• The data was not correct or it was not possible to read it
correctly.
• Recording the music data failed as an abnormality
occurred while recording it.
• The TOC data was not correct.
• It was not possible to read the TOC data.
• It was not possible to rewrite UTOC correctly and an
abnormality occurred while rewriting it.
• The disc was loaded but it was not possible to draw in
FOCUS.
• The total number of TNO and NAME characters was "0"
as a result of reading UTOC.
• UTOC can be read but cannot be rewritten.
• The EEPROM data is not correct
Description
The head fails to move up.
The head fails to move down.
HINF (IC1401 No.97 pin)
< 1.3 V
> 3.06 V
1.853 - 2.48 V
1.3 - 1.853 V
Countermeasure
• Wrong operation procedure was used. Try
again by using the correct procedure.
• Check according to troubleshooting.
• Check the temperature of the area where the
unit is used.
• Use another disc as there is an abnormality in
TOC or UTOC data or the disc has a scratch or
other faulty condition.
• The TOC data recorded in the disc is not in
compliance with the MD standard.
• Use another disc as the disc has a scratch or
other faulty condition.
• Use another disc as the disc has a scratch or
other faulty condition.
• Check that the disc is free from scratch, dust,
finger print, black spot, etc. and that
decentering, face deflection, etc. are not
excessive.
• Check if the disc is recordable by actually
recording.
• Check if the recording head contacts properly
and if wiring from the circuit board to the
recording head is free from breakage.
• Try again after resetting and if still NG, replace
EEPROM.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents