5
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
7
Re-connect the battery terminal and test the unit for proper operation. Mount the head unit/kit
assembly to the sub-dash with (2) screws. Place the Faceplate into the dash trim bezel and
mount with (3) 3/8" Phillips screws supplied.
3
6
"A"
Locate the upper dash tab in the sub-dash and
bend the tab down. ("A")
rev. 100103
KIT FEATURES
Shaft and
DIN unit
99-6540
provisions
INSTALLATION
KIT COMPONENTS
INSTRUCTIONS
Radio Housing
APPLICATIONS
CAR
DODGE
Faceplate
Van (full size) 1990-97.............................................1-3
(3) 3/8" Phillips
Screws
TOOLS REQUIRED
Phillips screwdriver
Cutting tool
1-800-221-0932
Drill
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
PAGE
www.metraonline.com