Periodic Maintenance Procedures
Rubber Parts of Clutch Master Cylinder/Slave
Clutch Master Cylinder Cup and Dust Seal Replacement
Remove the clutch master cylinder (see Clutch Master
Cylinder Removal in the Clutch chapter).
Remove the seal cover [A], circlip [B], connector [C] and
Special Tool - Inside Circlip Pliers: 57001-143
Unscrew the locknut [E] and pivot bolt [F], and remove the
Pull the circlip [G].
Pull out the piston assy [H].
Seal Cover [A]
Piston Assy [H]
Before assembly, clean all parts including the master
cylinder with clutch fluid or alcohol.
Use only disc brake fluid, isopropyl alcohol or ethyl
alcohol for cleaning parts. Do not use any other
fluid for cleaning these parts. Gasoline, motor oil
or any other petroleum distillate will cause deterio-
ration of the rubber parts. Oil spilled on any part will
be difficult to wash off completely, and will eventu-
ally deteriorate the rubber used in the cylinder.
Apply clutch fluid to the parts removed and to the inner
wall of the cylinder.
Take care not to scratch the piston or the inner wall of the
Torque - Clutch Lever Pivot Bolt: 1.0 N·m (0.10 kgf·m, 8.9
Clutch Lever Pivot Bolt Locknut: 5.9 N·m (0.60
kgf·m, 52 in·lb)
Install the clutch master cylinder (see Clutch Master Cylin-
der Removal in the Clutch chapter).
PERIODIC MAINTENANCE 2-57