Table of Contents
Advertisement
Quick Links
INSTALLATION INSTRUCTIONS FOR PART 99-6506
99-6506
KIT FEATURES
• DIN Head unit provision with pocket
• ISO DIN Head unit provision with pocket
KIT COMPONENTS
A) Radio Housing • B) ISO Brackets • C) Trim Plate
A
Phillips Screwdriver • Small Flat Blade Screwdriver • Cutting Tool • T-15 Torx Driver
1-800-221-0932
© COPYRIGHT 2004-2009 METRA ELECTRONICS CORPORATION
APPLICATIONS
Chrysler Pacifica
2004-2008
B
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Wire harnesses:
• CHTO-02 Chrysler/Dodge amplified interface 2002-up
• 70-6506 Chrysler/Dodge amplified bypass harness 2002-up
Antenna adapter:
• 40-CR10 - Chrysler/Dodge antenna adapter 2002-up
TOOLS REQUIRED:
www.metraonline.com
C
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Metra Electronics 99-6506
Summary of Contents for Metra Electronics 99-6506
- Page 1 INSTALLATION INSTRUCTIONS FOR PART 99-6506 Chrysler Pacifica 99-6506 KIT FEATURES • DIN Head unit provision with pocket • ISO DIN Head unit provision with pocket KIT COMPONENTS A) Radio Housing • B) ISO Brackets • C) Trim Plate Phillips Screwdriver • Small Flat Blade Screwdriver • Cutting Tool • T-15 Torx Driver 1-800-221-0932 ©...
- Page 2 99-6506 T ABLE OF CONTENTS Dash Disassembly Chrysler Pacifica 2004-2008 ......1 Kit Assembly Din Head Unit Provision.
- Page 3 99-6506 CHRYSLER PACIFICA 2004-2008 Disconnect the negative battery terminal to prevent an accidental short circuit. Loosen (1) T-15 Torx screw from the front side of shift knob and pull up to remove. (Figure A) NOTE: For models equipped with no release lever on shift knob just turn counter-clockwise to remove.
- Page 4 99-6506 DIN HEAD UNIT PROVISION Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs outward. (Figure A) Slide the aftermarket head unit into the cage and secure. Snap the Trimplate into the Radio Housing.
- Page 5 99-6506 ISO DIN HEAD UNIT PROVISION Mount the ISO Brackets to the head unit with the screws supplied with the unit. (Figure A) Slide the head unit into the radio opening until the side clips engage. Snap the Trim Plate into the Radio Housing.
- Page 6 99-6506 FINAL ASSEMBL Y 1 Locate the factory wiring harness in the dash and make the connection as shown. Metra recomends using the proper mating adapter and making the connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.)
- Page 7 95-6506 NOTES...
- Page 8 99-6506 INSTRUCTIONS 1-800-221-0932 www.metraonline.com REV. 04/20/09 © COPYRIGHT 2004-2009 METRA ELECTRONICS CORPORATION INST99-6506...
Need help?
Do you have a question about the 99-6506 and is the answer not in the manual?
Questions and answers