Aiwa ADC-EX108 Service Manual
Stereo car cd changer system
Hide thumbs
Also See for ADC-EX108:
- Operating instructions manual (12 pages) ,
- Service manual (8 pages) ,
- Service manual (30 pages)
Advertisement
Quick Links
Download this manual
See also:
Service Manual
Advertisement
Related Manuals for Aiwa ADC-EX108
Summary of Contents for Aiwa ADC-EX108
- Page 1 ADC-EX108 ADC-M105 YL,YH SERVICE MANUAL STEREO CAR BASIC CD MECHANISM : 8ZG-4 RNF CD CHANGER SYSTEM • This Service Manual is the "Revision Publishing" and replaces "Simple Manual", (S/M Code No. 09-003-404-5T7). S/M Code No. 09-003-404-5R7...
-
Page 2: Specifications
SPECIFICATIONS <Compact disc changer> System Compact disc digital audio system Frequency Response 5 Hz - 20 kHz Wow and flutter Below measurable limit Signal to noise ratio 91 dB or more Outputs Line output (for changer connector only) Operating temperature C to 55 Dimensions 254 x 83 x 173mm (w/h/d) -
Page 3: Protection Of Eyes From Laser Beam During Servicing
PROTECTION OF EYES FROM LASER BEAM DURING SERVICING CAUTION This set employs laser. Therefore, be sure to follow carefully Use of controls or adjustments or performance of proce- the instructions below when servicing. dures other than those specified herin may result in hazardous radiation exposure. -
Page 4: Service Jig And Tools
SERVICE JIG AND TOOLS 1. How to Use the Repair Jig Use the following repair jig kit for servicing. Part name Part code PWB JIG For 10 CD changer JIG-ADC-EX106 SV-J00-090-010 TRANSISTOR The kit contains the following parts (Refer to Fig-1) ; PWB KEY FFC (26P/25 cm) 1 pcs... - Page 5 Perform wirings to the C.Bs. Refer to Fig-5/-6; • Be sure to connect the wires coming from the P.W.B. JIG to the same connecting points on the MAIN C.B as follows. Connect the motor wires and sensor (PD201) wires that are removed in step (2) to the P.W.B. JIG.
- Page 6 Fig-8 PWB KEY Fig-8 Fig-9 +12V Fig-7 2) Connect the wires as follows (Refer to Fig-9); • Connect wire for +12 V power to BACK UP of ICP601 by soldering. • Connect ICP601 and ACC pattern land by soldering a wire.