5
Fig. A
2-SHAFT HEAD UNITS: Slide the aftermarket head unit into the kit and secure with shaft
nuts. (see Fig. A)
DIN HEAD UNITS: Cut and remove the shaft supports from the Extension Housing. Slide
the DIN cage into the kit and secure by bending the metal locking tabs down. Slide the
aftermarket head unit into the cage until secure. (see Fig. B)
6
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
3
Fig. B
7
Re-connect the battery terminal and test the unit
for proper operation. Mount the head unit/kit
assembly to the sub-dash with those screws
previously removed.
rev. 200202
KIT FEATURES
Various
mounting depth
99-4700
alternatives
INSTALLATION
KIT COMPONENTS
INSTRUCTIONS
Radio Housing
APPLICATIONS
GENERAL MOTORS 1982-02
VEHICLES EQUIPPED WITH J-2000 PANEL-STYLE
Extension Housing
FACTORY HEAD UNIT PROVISIONS
(SEE INSIDE FOR SPECIFIC APPLICATIONS)
Spacers
(6) Keps Nuts
(6) Carriage Bolts
TOOLS REQUIRED
Phillips screwdriver
Cutting tool
1-800-221-0932
Adjustable wrench
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
www.metraonline.com