Configuring The Lan Controller - Asus ASMB2 User Manual

ASMC Help Menu options ASMC Help Menu options ASMC Help Menu options ASMC Help Menu options ASMC Help Menu options
O p t i o n s O p t i o n s O p t i o n s
O p t i o n s O p t i o n s
-flash -load filename
-sdr -save filename
-sdr -load filename
-kcs[smic/bt/pci_smic] NetFn command data....
-bmc_ip [ip_addr]
(e.g., bmc_ip 10.10.10.20)
--pet_ip_mac [ip_addr] [mac_addr]
(e.g., pet_ip_mac 10.10.10.20 010203040506)
-adm_name
-user_name
-adm_password
-user_password
-init_asmb2
-sol_baud [baud rate]
(e.g., sol_baud 57600)
-bmc_info
2.5.3 2.5.3 2.5.3

Configuring the LAN controller

Configuring the LAN controller Configuring the LAN controller
2.5.3 2.5.3 Configuring the LAN controller Configuring the LAN controller
Before you can establish connection to the ASMB2 board, you must
configure the LAN port for server management used by the remote server
to connect to the local/central server.
To configure the LAN port of the remote server:
1. On the prompt, type a s m c - i n i t _ a s m b 2
screen displays the auto-detected information including the system/
motherboard name, and the IPMI2.0 interface. The screen also shows
the status of the ASMB2.
2. Shut down the remote server, then disconnect the power plug from the
electrical socket to initialize the ASMB2.
3. Restart the remote server from the support CD.
4. Run the ASMC utility from the support CD following the instructions in
the previous section.
A S U S A S M B 2 A S U S A S M B 2
A S U S A S M B 2 A S U S A S M B 2 A S U S A S M B 2
new_name_string
new_name_string
new_adm_password Change the administration password
new_user_password Change the user password
a s m c - i n i t _ a s m b 2, then press <Enter>. The a s m c - i n i t _ a s m b 2 a s m c - i n i t _ a s m b 2
a s m c - i n i t _ a s m b 2
D e s c r i p t i o n D e s c r i p t i o n D e s c r i p t i o n
D e s c r i p t i o n D e s c r i p t i o n
Update the ASMB2 firmware
Save the SDR data to file
Update the SDR data from file
Send IPMI command
Write the BMC IP address
Write the PET destination IP and MAC
addresses
Change the administration name
Change the user name
Initialize ASMB2
Set the communication Baud rate
Displays the BMC and PET IP and MAC
addresses
2 - 1 1 2 - 1 1
2 - 1 1 2 - 1 1 2 - 1 1