Checking the Ink Status with the Ink Lamps
1. Make sure that the power is turned on, then, holding both sides of the paper output tray,
gently open it.
2. Lift the operation panel and open until it stops.
3. Check the ink lamp.
Close the operation panel after checking the ink lamp status.
• The ink lamp is on.
The ink tank is correctly installed.
• The ink lamp is flashing.
Flashing slowly (at around 3-second intervals)
The ink is running low. Prepare a new ink tank.
The resulting print quality may not be satisfactory, if printing is continued under this condition.
Flashing fast (at around 1-second intervals)
- The ink tank is installed in the wrong position.
- The ink has run out.
Make sure that the ink tank is installed in the correct position as indicated by the label on the print
head holder. If the position is correct but the lamp flashes, there has been an error and the
machine cannot print. Check the error message displayed on the touch screen.
• The ink lamp is off.
The ink tank is not installed properly or the function for detecting the remaining ink level is
disabled. If the ink tank is not firmly in place, make sure that the orange protective cap has been
removed from the bottom of the ink tank, then press on the top of the ink tank until the ink tank
clicks into place.