Table of Contents
Advertisement
2.1
SECTION II--INSPECTION, INSTALLATION, AND INTERFACES
INTRODUCTION,
This section
contains
information
pertinent to the inspec-
tion, installation, and interfaces of the Tandon TM600 family
of rigid disk drives.
The
electrical
interface
between
the
drive
and the host
system is via
four
connectors.
Jl provides control signals
for the drive.
J2
provides
for
the radial connection of
read/write
data
signals.
J3 provides for D. C. power.
J4
provides
for
frame ground.
Figure 3 contains the locations
of the interface connectors.
2.2
UNPACKING
AND
INSPECTION
The
drive
is
shipped
in
a
protective
container which,
when bulk packaged,
minimizes
the
possibility
of
damage
during shipment.
The following procedure is the recommended
method of uncrating the
drive.
1.
Place the shipping container on a flat work surface.
2.
Remove
the
upper
half
of
the
inner container.
3.
Remove
the
drive
from
the
lower
half
of
the
inner container.
4.
Check the model number and top assembly description
against the packing slip.
5.
Visually
examine
the
contents
of
the
shipping
container for possible damage.
6.
Notify
the
is found.
carrier
immediately
if any damage
7.
The
inside
chamber
of
the
drive is
a sealed
compartment that must not be opened.
NOTE
REMOVAL
OF
THE
COVER
INVALIDATES THE WARRANTY.
2-1
OF
THE
DRIVE
Hide quick links:
Advertisement
Table of Contents
