After editing, pressing the F4 button saves the edited setting
data and the display returns to the Map adjustment screen.
If the Cancel button is pressed, the currently displayed data is
discarded and the display returns to the Map adjustment
To continue editing of the setting data, or to save the data,
press the F2, F3 or F4 button.
F2: Adjusting the ignition timing of the same data setting
(Refer to p. 60.)
F3: Changing the mapping points (Refer to p. 64.)
F4: Saving the data into SD memory card (Refer to p. 68.)
If the Cancel button is pressed at Map adjustment screen, the
message shown in the drawing appears.
Pressing the F1 button discards the current setting data and
returns the display to the Setting selection screen.
Pressing the F2 button returns the display to the Map
Adjustment of ignition timing
The ignition timing can be advanced/retarded (by degree) for
each mapping point specified by engine speed and throttle
Perform the procedure following the steps of this text while
referring to the flowchart shown below. The following description
is to use a sample data. The procedure to use a user library data
is almost the same.