Konica Minolta FK-502 Service Manual page 98

ERROR CODES
The error in the Txx/Rxx system may be caused under the effect of line noise, etc. even in usual operating con-
dition.
If the error arises often, output the Activity Report, Fax Setting List, Protocol Trace List, Parameter List, Address
Book List, Group Address List and Program List and obtain detailed information on the error status, conditions
which may cause the error, etc. from the user and contact the Support Center.
Code No. Category
T00 Sending
T01 Sending
T02 Sending
T03 Sending
T04
T05
T06 Sending
T07
T08 Sending
T09 Sending
T10
T11 Sending
T12 Sending
T13 Sending
T14
T15
T16
T17
T18 Sending
T19
T20
T21
T22
T23
T24
5-6
Contents of Error
T1 Timeout. No response
obtained from the machine on
the other end of the line. (35
second)
T1 over after the mode has
been changed (35 seconds)
DCN reception in DIS waiting
Unexpected command recep-
tion in DIS waiting
Reserved
FIF not matching with the
remote station (remote station
without the function).
DCN reception in CFR/FTT
waiting
Not used
Training failure at 2400bps
No response to DCS
Reserved
DCN reception while waiting for
post message responses
Unexpected command recep-
tion while waiting for post mes-
sage responses
No response while waiting for
post message responses
Not used
Reserved
Reserved
Reserved
No reception ability in a remote
station
Not used
Reserved
Reserved
Reserved
Reserved
Reserved
FK-502/Network Fax Service Manual Ver.3.0
How to correct
Check that the address number is
correct.
The remote station may not receive
the data due to paper shortage, full
memory, etc.
The line may be in trouble. Check the
line noise.
The line may be disabled because
the user on the remote station
disconnected it.
The remote station may not receive
the data due to paper shortage, full
memory, etc.
The remote station may not receive
the data due to paper shortage, full
memory, etc.
The remote station may not receive
the data due to paper shortage, full
memory, etc.