Download  Print this page

Searching A Track By Listening To Track Passages - Zappintm; Radio; Storing And Receiving Stations; Storing Automatically - Btm - Sony CDX-GT440U Operating Instructions Manual

Fm/am compact disc player.
Hide thumbs

Advertisement

.....
Searching a track by listening to
track passages - ZAPPINTM
While playing back short track passages in a CD
or USB device in sequence, you can search for a
track you want to listen to.
ZAPPIN mode is suitable for searching for a
track in shuffle or shuffle repeat mode.
~
(BACK)
Select button
ZAP
1
Press
(ZAP)
during playback.
After "ZAPPIN" appears in the display,
playback starts from a passage of the next
track.
The passage is played for the set time, then a
click sounds and the next passage starts.
Track
L----t-------'
The part of each track to
playback in ZAPPIN mode.
2
Press the select button or
(ZAP)
when
a track you want to listen is played
back.
The track that you select returns to normal
play mode from the beginning.
To search a track by ZAPPIN mode again,
repeat steps I and 2.
Tips
• You can select the playback time from about 6
seconds/9 seconds/30 seconds (page 17). You
cannot select the passage of the track to playback.
• Press
(SEEK)
+/- or
(D/m
(ALBM -/+) in ZAPPIN
mode to skip a track or album.
• Pressing
~
(BACK) also confirms a track to
playback.
12
Radio
Storing and receiving stations
Caution
When tuning in stations while driving, use Best
Tuning Memory (BTM) to prevent an accident.
Storing automatically -
8TM
1
Press
(SOURCE/OFF)
repeatedly until
"TUNER" appears.
To change the band, press
(MODE)
repeatedly. You can select from FM I, FM2,
FM3, AM I or AM2.
2
Press and hold the select button.
The setup display appears.
3
Press the select button repeatedly
until "BTM" appears.
4
Press
(SEEK)
+.
The unit stores stations in order of frequency
on the number buttons.
A beep sounds when the setting is stored.
Storing manually
1
While receiving the station that you
want to store, press and hold a
number button (CD to
®)
until
"MEM" appears.
Note
If you try to store another station on the same number
button, the previously stored station will be replaced.
Receiving the stored stations
1
Select the band, then press a number
button (CD to
®).
Tuning automatically
1
Select the band, then press
(SEEK)
+/-
to search for the station.
Scanning stops when the unit receives a
station. Repeat this procedure until the
desired station is received.
Tip
If you know the frequency of the station you want to
listen to, press and hold (
SEEK)
+/- to locate the
approximate frequency, then press (
SEEK)
+/-
repeatedly to fine adjust to the desired frequency
(manual tuning).

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: