Canon MG7500 series Online Manual page 283

Hide thumbs Also See for MG7500 series:

Table of Contents

• Tapping Details displays the security setting.

The password required when connecting from the external device is also displayed.

• You can specify the access point name (SSID) and the security setting optionally.

Setting of the Access Point Mode

7. Tap OK to start the connection.

The access point mode is enabled and the machine can be used as an access point.

Printing/Scanning with the Access Point Mode

Print/Scan with the access point mode following the procedure below.

1. Connect an external device such as a computer or a smartphone to the machine via

wireless LAN.

Perform wireless LAN settings with your external device, then assign the access point name specified

for the machine as a destination.

• For details on how to perform wireless LAN settings with an external device, refer to the

device's instruction manual.

• When a WPA2-PSK (AES) password is valid on the machine, entering the password is required

to connect an external device to the machine via wireless LAN. Enter the password specified for

the machine.

2. Start printing or scanning from an external device such as a computer or a smartphone.

• For details on how to print or scan from an external device such as a computer or a smartphone

via wireless LAN, refer to the device's or application's instruction manual.

How to terminate the Access Point Mode

In environments that the machine is connected with the computer over the wireless LAN usually, set the

machine to the wireless LAN connection following the procedure below when you finish using the machine

with the access point mode temporarily.

1. Flick the HOME screen, then tap

Using the Operation Panel

Device settings.

Troubleshooting