Removing And Replacing The Battery - HP t510 Hardware Reference Manual

Table of Contents

Advertisement

If you install a USB mouse and a USB keyboard in the secure USB compartment, route the cables
around and through the clips, then out the secure cable routing slot, as shown in the following
illustration.
Figure 2-7
Using the secure cable routing slot

Removing and Replacing the Battery

Before beginning the replacement process, review
General Hardware Installation Sequence
on page 10
for procedures you should follow before and after installing or replacing hardware.
WARNING!
Before removing the side access panel, ensure that the thin client is turned off and the
power cord is disconnected from the electrical outlet.
To remove and replace the battery:
1.
Locate the battery on the system board.
16
Chapter 2 Hardware Changes

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents