Technical Information - Ariston PH 604 Instructions For Installation And Use Manual

Electrical Connection
The electric cooktops are not fitted with a power supply
cord because the type of cord used depends on the
connection to the mains (see the wiring diagram below). To
connect the cable, proceed as follows:
Open the terminal box by removing the "V" screw and
taking off the cover.
V
Connect the wires as shown in the diagram.
400V 3N ~
H05RR-F 5x1.5 CEI-UNEL 35363
400V 2N ~
H05RR-F 4x1.5 CEI-UNEL 35363
230V 1N ~
H07RN-F 3x2.5 CEI-UNEL 35364
Fix the cable in place with the "F" cable clamp, close the
lid and fasten it with the "V" screw.
Voltage and frequency of electrical power supply:
~
230V 1N
3 4
1 2
T
R S
3 4
1 2
S N
R
3 4
1 2
R

Technical Information

~
/ 400V 3N 50-60Hz 7000W
Electrical Connection for Gas Cooktop
Fit the supply cord with a standard plug for the demand
rate indicated on the rating plate or connect it directly to
the electrical mains. In the latter case, a single pole switch
must be placed between the appliance and the mains, with
a minimum opening between the contacts of 3 mm in
compliance with current safety codes (the earthing wire
must not be interrupted by the switch). The power supply
cord must be positioned so that it does not reach a tempe-
rature in excess of 50°C above room temperature at any
point.
Before making the actual connection, make sure that:
•
The fuse and electrical system can withstand the load
required by the appliance;
•
That the electrical supply system is equiped with an
efficient earth hook-up according to the norms and
regulations prescribed by law;
•
That the plug or switch is easily accessible.
N.B: Never use adaptors, shunts or the like because they
could overheat or cuase burns.
Attention: If the appliance is installed above a built-in oven,
5
the electrical connection for the cooktop must be
N
independent of that for the oven not only for safey reasons,
5
but also to facilitate removable of the oven in the future.
5
N
This appliance complies with the following European
Economic Community directives:
- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent
modifications;
- 89/336/EEC of 03/05/89 (Electromagnetic Compatibility)
and subsequent modifications;
- 93/68/EEC of 22/07/93 and subsequent modifications.
9