Before Use; Electrical Safety - Black & Decker STC1840 Original Instructions Manual

Table of Contents

Advertisement

ENGLISH
Never attempt to charge non-recharge-
u
able batteries.
Have defective cords replaced immedi-
u
ately.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
$
The charger is intended for
indoor use only.
Read the instruction manual

before use.

Electrical safety

#
Your charger is double insu-
lated; therefore no earth wire is
required. Always check that the
mains voltage corresponds to the
voltage on the rating plate. Never
attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Labels on appliance
The following warning symbols are found on the appliance:
Read the manual prior to operation.
Wear safety glasses or goggles when operating
this appliance.
N
Wear suitable ear protectors when operating this
appliance.
8
(Original instructions)
Switch the tool off. Before performing any
maintenance on the tool, remove the battery
from the tool.
K
from the cutting area.
R
Do not expose the appliance to rain or high
humidity.
Directive 2000/14/EC guaranteed sound power.
Features
This appliance includes some or all of the following features.
1. On/off switch
2. Battery
3. Auxillary Handle
4. Runtime Extender
5. Locking Clamp
6. Trimmer Head
7. Edge Guide Wheel
8. Guard
9. Spool Cap
Assembly
Warning! Before assembly, make sure that the tool is
switched off and the battery has been removed.
Turn the trimmer upside down so that you are looking
u
down at the spool cap (9).
Remove the screw from the guard with a phillips screw-
u
driver.
Turn the guard (8) upside down and slide it fully onto the
u
motor housing (6). Make sure the tabs (10) on the guard
engage the ribs (11) on the motor housing as shown in
the housing slot (26)
Continue to slide the guard on until you hear it "snap" into
u
place.
Using a phillips screwdriver, insert the guard screw as
u
Once the guard is installed, remove the covering from the
u
line cut-off blade, located on the edge of the guard.
Warning! Never use the tool unless the guard is properly
Push the Auxiliary handle (3) onto the tube (10).
u
Slide the bolt (11) into the hex-shaped hole in the handle
u
and through to the opposite side.
Tighten the knob (12) onto the bolt by turning it clockwise.
u

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents