Advertisement
3. Plug the Power Cord into the DTA
Note: If you are using an IR Extender, DO NOT plug the power cord into an electrical outlet until after the IR Extender
has been installed.
4. Connecting the IR Extender
a. If you are using the IR Extender, connect it to the IR port on the back of the DTA.
b. Remove the paper backing of the adhesive pad from the bottom of the IR receiver.
c. Find a place towards the lower right corner on the front of the TV where nothing will block the IR sensor during normal
TV operation.
Note: Place the IR Receiver away from compact fluorescent lights, plasma TV displays and LCD HDTVs. Remote control may be
negatively impacted if the sensor is too close to these types of devices.
d. Attach the IR Extender Receiver by firmly pressing on the IR Receiver.
5. Power Up
a. Connect the DTA to power surge protector.
b. The DTA should power on. (It is possible that your DTA will show a red LED or a green LED on the front panel.
As long as your video is displaying correctly on the TV, the LED color does not matter.)
6. Program the Remote Control to the TV
Option 1: Universal Remote (chart on right)
a. Manually turn the TV on.
b. Press and hold SETUP
c. Enter the first code (from the detailed instructions included with the remote) for the brand
of TV you have (a full listing of codes can be found at www.urcsupport.com).
d. Press the TV Power
not turn off, repeat steps b-d using the next code listed for the TV.
Option 2: Cisco Remote
a. Manually turn the TV on.
b. Press and hold the PROG and TV POWER buttons until the LED on the remote turns on,
then release both buttons.
c. Enter the first code (from the detailed instructions included with the remote) for the brand
of TV you have (a full listing of codes can be found at www.urcsupport.com). The LED will flash twice.
d. Press the TV Power button. If the TV turns off, verify that the VOL+ and VOL- buttons and MUTE button
also work. If all functions work, the code is correct. If the functions do not work, repeat steps b-d
using the next code listed for the TV.
Thank you for choosing Charter Communications
button on the remote control until the LED blinks twice.
SETUP
button to test. If the TV turns off, setup is complete. If the TV does
4
Hide quick links:
Advertisement
