Table of Contents
Advertisement
Connecting devices
Connecting devices
Connecting cord-based analogue devices
The internal phone numbers Int.21/Int.22 are pre-assigned to the TAE connections.
Devices connected to them must
not be registered on the base.
◆
be set to tone (DTMF) dialling (pulse dialling not supported).
◆
In addition, the corresponding device type must be set and device-specific additional
settings made.
No costs are displayed on the connected devices. However, accumulated costs are
recorded on the base and can be checked using an added-feature handset or on a PC.
Device types
The following settings are possible (Defining the device type, see Page 30).
◆
Telephone
◆
Fax
◆
Modem
Answering mach. see Page 27, Connecting an answering machine
◆
◆
Neutral
◆
Door type1
Doortype2(DTMF) see Page 33, Connecting door type 2
◆
◆
No function
i
Note the explanations below for the device types and their additional
device-specific settings.
Connecting telephones
By default, the two TAE connections are set to Telephone.
This means that the base is ready to use with a telephone (with tone dialling/DTMF) con-
nected to Int.21 or Int.22 even without a handset.
If you also want to use this telephone to make internal calls, automatic line seizure for
the associated TAE connection must be deactivated. For external connections, it is then
necessary to dial a zero first.
Information on making calls using devices on the TAE connection can be found in the
handset operating instructions.
26
see Page 26, Connecting telephones
see Page 27, Connecting a fax machine
see Page 27, Connecting a modem
see Page 27, Connecting a fax machine
see Page 32, Connecting door type 1
see Page 28, No device connected
Advertisement
Table of Contents
