Table of Contents
Advertisement
A recovery image of the software on your computer is stored on the Hard
Disk Drive, and can be copied to either disc media or USB Flash Memory
by using the following steps:
1.
2.
3.
4.
5.
Restoring the pre-installed software from your created
Recovery Media
If the pre-installed files are damaged, you are able to use the Recovery
Media you have created to restore the computer to the state it was in when
you originally received it. To perform this restoration, do the following:
1.
2.
User's Manual
Select either blank disc or USB Flash Memory.
The application allows you to choose from a variety of different media
onto which the recovery image can be copied including disc media
and USB Flash Memory.
Some of the disc media might not be compatible with the optical disc
drive connected to your computer. You should therefore verify that the
optical disc drive supports the blank media you have chosen before
proceeding.
USB Flash Memory will be formatted and all the data in the USB Flash
Memory will be lost when proceeding.
Turn on your computer and allow it to load the Windows operating
system from the Hard Disk Drive as normal.
Insert the first blank disc into the optical disc drive tray, or insert the
USB Flash Memory into one available USB port.
Click Recovery Media Creator under TOSHIBA group in All apps.
After Recovery Media Creator starts, select the type of media and the
title you wish to copy, and then click the Create button.
When you reinstall the Windows operating system, the hard disk will
be reformatted and all data will be lost.
Make sure to use the default Boot Mode option in TOSHIBA Setup
Utility before restoring.
Launch the TOSHIBA Setup Utility.
Refer to the
TOSHIBA Setup Utility
In the TOSHIBA Setup Utility screen, select Advanced -> System
Configuration -> Boot Mode.
Note: Please skip the following contents if you cannot find the Boot
Mode option in your system.
section for further information.
2-14
Advertisement
Table of Contents
