Asus 200/266 MHZ FSB AGP 4X User Manual page 36

3. HARDWARE SETUP
20) ATX Power Supply Connector (20 pin block ATXPWR)
This connector connects to an ATX power supply. The plug from the power sup-
ply will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.
IMPORTANT:
on the +5-volt standby lead (+5VSB). You may experience difficulty in power-
ing ON your system if your power supply cannot support the load. For Wake-
On-LAN support, your ATX power supply must supply at least 720mA +5VSB.
A7V133-M ATX Power Connector
21) IDE Activity LED (2 pin IDELED)
This connector supplies power to the cabinet's IDE activity LED. Read and
write activity by devices connected to the Primary/Secondary IDE and Primary/
Secondary ATA100 connectors will cause the LED to light up.
A7V133-M IDE Activity LED
36
Make sure that your ATX power supply can supply at least 10mA
Power Supply On
A7V133-M
A7V133-M
ASUS A7V133-M User's Manual
+3.3 Volts
+3.3 Volts
+3.3 Volts
-12.0 Volts
Ground
Ground
+5.0 Volts
Ground
Ground
+5.0 Volts
Ground
Ground
Ground
Power Good
-5.0 Volts
+5V Standby
+5.0 Volts
+12.0 Volts
+5.0 Volts
IDELED
TIP: If the case-mounted LED does not
light, try reversing the 2-pin plug.