Recording An Input Signal From An External Device - Sony PMW-EX30 Operating Instructions Manual

To perform dubbing
1
Set the video format to SP 1080/60i
(when "Country" is set to "NTSC
Area") or SP 1080/50i (when
"Country" is set to "PAL Area") on
this unit.
2
Set "i.LINK I/O Select" (see page 91)
of the VIDEO SET menu to
"DVCAM" or "HDV".
Note
Be sure to turn off the power of the
connected devices before changing the
"i.LINK I/O Select" setting.
3
Put the HVR-M35 into recording
standby mode.
4
Insert the SxS memory card into this
unit and cue up the clip you want to
dub.
5
Start recording on the HVR-M35.
6
When dubbing finishes, stop recording
on the HVR-M35 and stop playback on
this unit.
Recording an input signal
from an external device
This section shows an example for
connecting this unit and the HVR-M35
HDV Videocassette Recorder to record the
playback picture from the HVR-M35 on an
SxS memory card. When the video format
is set to SP 1080/60i (when "Country" is set
to "NTSC Area") or SP 1080/50i (when
"Country" is set to "PAL Area") on this
unit, HDV-format signals can be recorded.
The timecodes superimposed on the i.LINK
input are recorded regardless of the settings
of the unit.
78 Connecting an External Device with the i.LINK Connector
On how to use the HVR-M35, refer to the Operating
Instructions supplied with the HVR-M35.
Notes
• DVCAM signals cannot be recorded on
this unit.
• Be sure to turn off the power of the
connected devices before switching the
output format (between HDV and
DVCAM).
HVR-M35
a)
HDV/DV
This unit
a) i.LINK cable
b) Set "i.LINK I/O Select" (see page 91) of the
VIDEO SET menu to "HDV".
b)
HDV/DV