freightliner cascadia Driver Manual page 60

02/23/2007
Fig. 5.19, PTO Switch
Eaton Automated Transmissions
NOTE: See Chapter 15
transmission operating instructions.
The SmartShift electronic transmission control is in-
stalled with the Eaton® Fuller® UltraShift
™
Eaton Fuller AutoShift
Shift control is operated by the fingers of the driver's
right hand, allowing both hands to remain on the
steering wheel.
A two-position driving mode slide switch is mounted
on the body of the control lever just before the
paddle widens out. The slide switch allows the driver
to choose automatic (AUTO) or manual (MAN) mode.
See Fig. 5.21.
Manual Transmissions
NOTE: See Chapter 14
transmission operating instructions.
If so equipped, the transmission range control and
splitter valves are attached to the gear shift knob.
The range-preselection lever allows the selection of
the low or high range for each transmission ratio. It is
used once during an upshift sequence and once dur-
ing a downshift sequence.
Dependent on the transmission model, some ratios
can be split using the splitter-control button.
Allison Automatic Transmissions
Automatic transmissions have up to six forward
speeds and one reverse speed. These transmissions
have electronic shift controls that can be pro-
PTO
f610894
for complete automated
™
and
transmissions. The Smart-
for complete manual
1
A
B
C
05/30/2012
A. Front View
B. Shift Requests
C. Four positions for engine brake settings
1. Engine Brake Symbol
2. D/N/R Switch
3. Mode Switch
4. Gear Shift Symbol
Fig. 5.20, Detroit Multifunction Control
grammed to allow the use of different geared
speeds. See Fig. 5.22.
Driver Controls
4
2
( + )
f270163a
3
( − )
5.10