freightliner cascadia Driver Manual page 39

From Temp Alert Screen
n = Number of
Active Fault Codes
dlAG
n
Tap
To Setup Screen (or Oil
Level Screen, if equipped)
01/31/2012
Alert Messages
The driver message center displays alert messages
when certain conditions occur. They are warnings,
cautions, or other messages that require the driver's
attention, but not all of them are critical to the opera-
tion of the vehicle.
NOTE: If there is more than one alert message
to display, tap the + switch or the MY INFO
switch to access the next message, and so on,
until all messages have been viewed.
More important messages take priority over less im-
portant messages. The order of priority is:
*If fault goes inactive,
display "noFault 1"
*FAULT
Press & Hold
01
Tap
AbS 11
Tap
SPN
Tap
FAIL 03
Tap
Fig. 4.11, ICU4 Diagnostic Screens
Press & Hold
123456
1. parking brake set (with the vehicle moving)
2. parking brake off (with the door open)
3. low oil pressure or high coolant temperature
4.
hard brake warnings (if equipped with roll stabil-
ity advisor)
5. low battery voltage
6. ambient temperature below 35°F (1.7°C)
7.
turn signal on
8. incoming instant or Qualcomm messages
9. service warnings
Instruments
*If fault goes inactive,
display "noFault n"
*FAULT
Press & Hold
nn
Tap
ECU 0
Press & Hold
Tap
123456
Press & Hold
SPN
Tap
FAIL 00
Press & Hold
Tap
f040802
4.14