Before you begin, read through these instructions and check that all parts are present.
Please note that Kawasaki cannot assume any responsibility for damage resulting from incorrect installation.
Kawasaki recommends that all genuine accessories should be fitted by an authorised Kawasaki dealer.
Apply Loctite or similar non-permanent locking agent for bolts and screws
1. Follow the steps shown in Img. 1,2,3,4,5 below to disassemble the seat (two screws), the grab rails.
Remove the four screws of the upper tail cover, pull the sides outward and remove the cover completely.
KAWASAKI MOTORS EUROPE N.V.
P.O. Box 532, 23100AM Hoofddorp
KIT ACCESSORY, SADDLEBAG BRACKETS (USA) (Version B)
Ninja 1000 (Z1000SX) 2011- (ZX1000G.., ZX1000H..)
Approx 1,5 h
(Pag 1 of 5)