PARTS AND CONTROLS
RECOIL
STARTER
GRIP
HANDLEBAR
LOCKING
KNOB (2)
OIL FILLER CAP
(P. 3)
SIDE DISCHARGE
GUARD
SPARK PLUG
CAP
FRONT CUTTING
HEIGHT ADJUSTMENT
LEVER (2)
FUEL VALVE ON
BLADE CONTROL
LEVER
THROTTLE LEVER
FUEL TANK CAP
MUFFLER
(P. 5)
REAR CUTTING
HEIGHT
ADJUSTMENT
LEVERS (2)
AIR
CLEANER
CARBURETOR
FUEL VALVE OFF
INITIAL MOWER SETUP
Adjust the Handlebar
1. Loosen the two locking knobs on the lower handlebar enough to
raise the handlebar into the mowing position.
2. Depress the blade control lever while raising the handlebar
BLADE CONTROL LEVER
3. Tighten the locking knobs securely.
Add Engine Oil
The mower is shipped WITHOUT OIL
in the engine. Remove the oil filler
cap/dipstick and add the entire
contents of the included bottle of oil
into the oil filler opening.
All Honda engines are run at the
factory prior to packaging. Most of the
oil is removed prior to shipment;
however, some oil remains in the
engine. The amount of oil left in the engine varies.
If you don't use the supplied oil, add enough SAE 10W-30 API service
category SJ or later oil to bring the oil level between the upper and
lower limit marks on the dipstick—without screwing the dipstick in
(approximately 12 to 13.5 ounces is required). See
Do not overfill the engine with oil. If the engine is overfilled, the
excess oil may get transferred to the air cleaner housing and air filter.
An indication of overfilling is white or blue smoke coming from the
muffler when the engine is running.
After filling the engine with oil, screw the filler/cap dipstick in and
remove the hang tag near the recoil starter grip that says "The engine
has no oil."
Please Register Your Mower
Please take a few minutes and register your purchase with Honda.
You can register by completing and mailing the registration card on
the back cover of this book or going online to
http://powerequipment.honda.com
Before Using Your Lawn Mower
Before using the lawn mower, all mower operators must read the
following sections:
• FOR YOUR SAFETY
(page
• BEFORE EACH OPERATION
• OPERATION
(page
6)
• MAINTENANCE SCHEDULE
LOCKING
KNOB (2)
page
5.
and click on Product Registration.
2)
(page
4)
(page
8)
3