Ceiling Loudspeaker System CS100 Installation Guide McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549...
Phone: 607-723-1545 Fax: 607-724-0549 Customer Service If it is determined that your McIntosh product is in need of repair, you can return it to your Dealer. You can also return it to the McIntosh Laboratory Service Department. For assistance on factory repair return procedure, contact the McIntosh Service Department at: McIntosh Laboratory, Inc.
The 3-way Loudspeaker System uses no more space than a typical 2-way System. When positioned near the rear or side walls of a room, the CS100 wide dispersion sound characteristics can be directed towards the side or rear of the seating position for direct-radiating surround sound or reflected off the side or rear wall to create a diffuse sound field surround.
The CS100 Ceiling Loudspeaker System is designed to mount into the ceiling of a typical room. Before choosing the location in the ceiling for the CS100, it is important to read “Location in the Room” for the best possible perfor- mance.
The CS100 is designed for indoor use only. Indoor rooms with high humidity levels should be avoided; i.e. an indoor swimming pool area, directly above a bathtub/shower/jacuzzi/sauna, etc.
Page 6
Refer to figure 12. Note: If the CS100 is to be used with two Power Am- plifiers (BIAMP), connect the cable from the Low Frequency Amplifier to the Low Frequen- cy Terminals. Connect the cable from the High Frequency Amplifier to the High Frequency Terminals.
Width is 13-3/4 inches (34.9cm) Depth is 13-3/4 inches (34.9cm) Height is 9-1/4 inches (23.5cm) Specifications The continuous improvement of its products is the policy of McIntosh Laboratory Incorporated who reserves the right to improve design without notice. Printed in the U.S.A.
Need help?
Do you have a question about the CS100 and is the answer not in the manual?
Questions and answers