Related Manuals for McCulloch 964814401
Summary of Contents for McCulloch 964814401
- Page 1 HT42/420 HT45/450 HT51/510 HT60/600 For all customer enquiries or for replacement parts, contact:- ☎ ☎ 0870 609 1901 www.flymo.com customer.services@husqvarna.co.uk...
-
Page 2: Carton Contents
Switch levers IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna Outdoor Products Customer Service Department direct Telephone : 0870 609 1901 If not used properly this Hedgetrimmer can be dangerous! This Hedgetrimmer can cause serious injury to the operator and others, the warnings and safety instructions must be fol- lowed to ensure reasonable safety and efficiency in using this Hedgetrimmer. - Page 3 General 1. Never allow children or people unfamiliar with these instructions to use the Hedgetrimmer. Local regulations may restrict the age of the operator. 2. Only use the Hedgetrimmer in the manner and for the functions described in these instructions. 3.
- Page 4 CABLES IMPORTANT • Use only 1.00mm size cable up to 30 metres length maximum. Maximum rating : 1.00mm size cable, 10 amps 250 volts AC. • YOUR HEDGETRIMMER IS SUPPLIED WITH CABLE WIRED DIRECTLY INTO THE PRODUCT. 1. Mains Cables and Extension Cables are avail- able from your local Approved Service Centre.
-
Page 5: Starting And Stopping
Before starting your Hedgetrimmer. 1. Form a loop in mains cable and push the loop through the hole in the handle as illustrated in Fig. B. 2. To secure, position the loop over the hook and pull back as illustrated in Fig. C. 3. -
Page 6: Caring For Your Hedgetrimmer
Caring for your Hedgetrimmer Cleaning (J) 1. Using a soft brush - remove debris from all 2. Wipe over surface of your hedgetrimmer • Lubricating the Cutting Blade For easier operation and longer life, lubricate the cutter blades before and after use. Apply the oil so that it runs between the two blades. -
Page 7: Environmental Information
Fails to Operate 1. Is the Power Turned On? 2. Check the fuse in the plug, if blown replace. 3. Fuse continues to blow? Immediately disconnect from the mains electricity supply and consult your local approved Service Centre. Cutting blade stops under load 1. -
Page 8: Service Recommendations
1. We strongly recommend that your product is serviced at least every twelve months, more often in a professional application. 2. Always use genuine Husqvarna Spare Parts. 3. Prepacked spares are available from most Husqvarna Outdoor Products stockists. 4. Your product is uniquely identified by a sil- ver and black product rating label 5.