Other Commands (Models Rs-613 Only ) - AstroStart RS-613 User Manual

Remote control engine starter
Hide thumbs Also See for AstroStart RS-613:
Table of Contents

Advertisement

OTHER COMMANDS
LOW TEMPERATURE MODE
In Low Temperature (Sentinel) mode, system starts your engine at 2½
hour intervals, for the duration that was set during previous usage. .
Each repeated command changes the runtime to the next setting (see
table).
To activate/deactivate Low Temperature mode press
buttons simultaneously.
Parking lights will flash according to corresponding runtime as listed in
the above table.
In the case of a manual transmission vehicle, the system must have detected a valid security sequence to allow the
activation of Low Temperature mode. (see "Safety sequence for manual transmission vehicles" on page 3).
If the system cannot execute the command (for example, security sequence not valid, hood is open), the low temperature
mode is deactivated confirmation will be different (lights: 3).
Applying brakes deactivates the Low Temperature mode.
LOCK/UNLOCK COMMANDS
If your vehicle is equipped with electric door locks, several functions can be operated by remote control.
These features are optional and may require purchasing additional equipment. Consult your dealer for advice.
Following systems can be controlled:
Door locks.
Trunk or hatchback release.
Interior lights.
LOCK
Press the
button. Doors are locked and parking light flashes once to confirm command has been received.
Parking light confirmation is sent as many times as command is repeated so you are sure that system has received the
command. Horn sounds once if option "Confirmation on 2nd lock" was set during installation.
UNLOCK
Press the
button. Doors are unlocked and parking light flashes twice to confirm command has been received.
The "Unlock" function can be programmed and connected in such a way that the first Unlock command only unlocks the
driver's door, while a following Unlock command unlocks the other door(s).
Dome light will turn on for 30 seconds every time (optional connection during installation):
Unlock command is sent.
Engine is stopped (ignition switch).
Continuous mode is activated.
This 30-second duration is cancelled when Lock command or Trunk command is sent, brakes are applied or key is inserted
in ignition and turned to RUN position.
(M
RS-613
)
ODELS
ONLY
Setting
Deactivated
4 minutes
8 minutes
and
18 minutes
Timings are doubled in diesel mode
Confirmation
1 blink
2 blinks
3 blinks
4 blinks
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rs-611Rs-711xr

Table of Contents